Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
- Automatic transmission
Specifications
Search of malfunctions - the general information
- Automatic transmission 722.5
Removal, check of a state and installation of the converter of rotation (hydrotransformer)
Removal and installation of the centrifugal regulator
Removal and installation of the sensor switch of blocking of a starter (permission of start)
Vacuum knot - installation details
Removal, service and installation of the secondary pump (AT to No. 3652931)
Removal and installation of a forward cover with the secondary pump
Removal and installation of the LB3 piston
Removal and installation of a back cover of transmission
Dismantling and assembly of valvate assembly of AT
Dismantling and assembly of transmission
Installation and check of a gap in a multidisk brake of B3
Measurement of a gap in B1 brake
Coupling of the raising transfer
Removal, installation and check of components of a brake of BS of the raising transfer and coupling of KS
Dismantling and assembly of the coupling of a free wheeling
Dismantling and assembly of planetary mechanisms
Dismantling and assembly of coupling of K1
Coupling of K2
Gear shifting selector lever
+ Automatic transmission 722.6
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Measurement of a gap in B1 brake
Preparation
|
|
| 1. Insert a radial epiploon (39) into the piston of a brake B1 (37). |
|
| 2. Implant a finger with laying and a sealing ring into B1 brake piston. The sealing edge has to be located outside. |
3. Fix a stripper (026) and tighten it on the transmission, install the measuring device (031).
4. Insert the piston of a brake B1 (37) with one press spring. |
|
5. Tighten the device (026) on a spindle. Make sure that the finger of the piston of a brake of B1 (37) which is established on a brake tape and a radial epiploon (39) are not injured.
6. Insert a lock ring (41), weaken and remove the device (026). |
|
|
Measurement and adjustment of a gap
|
|
| 1. Tighten the measuring device (031) by hand to resistance. |
|
| 2. Having put on a key a bolt, screw the measuring device (031) for a bolt, counting speed until the moment in 1 N. Rezba of the measuring device is defined has a step of 1 mm so one turn is equal to a gap in 1 mm. |
|
| 3. Weaken the device (026) and remove the brake piston if it is necessary. |
|
| 4. Adjust a gap, having inserted or having removed laying (136) on a finger (38). Thickness of laying: 0.5, 1.0 and 1.5 mm. |
|
| 5. Install a cover (40) of the piston of a brake and the second press spring (35) into place in the measuring device, insert a lock ring and unscrew the device (026). |
|
|
|
|