Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car


Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 of the issue)
      Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of the steering drive
      Removal and installation of cross steering draft
+ Body
+ Onboard electric equipment






Removal and installation of the drive of telescopic adjustment of a steering column

Removal

 PERFORMANCE ORDER

1. Turn off a bolt (84) and take the telescopic drive (M20m1).
2. Remove the blocking device (84b) and take a finger (84a) from an external pipe (81a).
3. Remove the telescopic drive of adjustment (M20m1).

Installation

 PERFORMANCE ORDER

1. Install the telescopic drive (M20m1) on an external pipe (81a) and implant a finger (84a).
2. Fix the blocking device (84b).
3. Using the indicator (22), adjust a pipe gap. For this purpose move the telescopic drive (M20m1) and a bolt (84) to an oblong opening so that the gap was reached. The gap has to be within 0.25 - 0.30 mm.
4. Tighten a bolt (84).