Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car

Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 of the issue)
      Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of the steering drive
      Removal and installation of cross steering draft
+ Body
+ Onboard electric equipment

Removal and installation of average steering draft

Removal

PERFORMANCE ORDER

1. Disconnect the damping shock-absorber (46) from average steering draft (11).
2. Holding an axial bolt, give nuts of fastening of average thirst for a steering bipod and the pendular lever. By means of a mandrel (051) No. 140 589 0063 00 and a stripper (053) No. 140 589 00 33 00 separate draft (11) from a bipod and the lever.

Installation

PERFORMANCE ORDER

1. Installation is made upside-down. Track reliability of fastening of spherical hinges of the longitudinal lever. Replace самоконтрящийся fixture (drags on with effort of 50 Nanometers). At connection to draft of the damping shock-absorber tighten fixture with effort of 40 Nanometers.
2. Check the angles of installation of forward wheels, in case of need make the corresponding adjustment.