Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car


Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
- Routine maintenance
   Specifications
   Active system of the warning of the term of approach planned THAT (ASSYST)
   Schedule of routine maintenance
   General information on control
   Check of levels of liquids, control of leaks
   Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
   Replacement of motive oil and oil filter
   Check of the brake system
   Check of fuel system, replacement of the fuel filter
   Check of a state and replacement of hoses of a motive compartment, localization of leaks
   Check of a condition of ridge belts of the streaming drive of auxiliary units
   Check of functioning of the cooling system and frost resistance of cooling liquid, liquid replacement
   Check of a condition of system of production of the fulfilled gases
   Check of the ATF level, replacement of the AT filter
   Visual check of tightness of automatic transmission
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts
   Check of the air conditioning system
   Lubricant of limiters of doors and cylinders of locks
   Visual control of a seat belt and block of a safety cushion
   Check of operability of headlights and horn
   Check of a state, adjustment and replacement of brushes of screen wipers
   Check of a condition of the battery, care of it and charging
   Replacement of the saloon filter
   Replacement of brake fluid
   Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment






Check of a condition of system of production of the fulfilled gases

Check has to be made at the cold engine therefore it is better to be engaged in it before a trip, the first for the present day, or not earlier than in three hours after switching off of the engine. Check a state twist systems of release, beginning from the engine and finishing with a cut of an exhaust pipe. Ideally this inspection should be carried out at the car lifted on the winch when from below to it there is free access. If the winch is inaccessible, the car and reliably install to a poddomkratta it on support.

 PERFORMANCE ORDER

1. Examine pipes and pipe connections on existence of signs of development of leaks, strong corrosion and mechanical damages. Check a state and reliability of fastening of all brackets and suspensions of system.

The suspensions located near the catalytic converter usually are made of heat resisting rubber and differ in red color.

2. At the same time examine the car bottom on existence of holes, corrosion, the dispersed seams and other defects allowing penetration of the fulfilled gases into interior of the car. Close up all openings suitable sealant.
3. The system of release, often is a source of a roar and other unpleasant sounds. Shake and pull pipes, mufflers and the catalytic converter. If any of components adjoin to elements of a body or details of a suspension bracket, replace fixture of system of release. In more detail the design of system of production of the fulfilled gases is considered in the Head of the Power supply system and release.
4. Examine the electrical wiring brought to a lambda probe. In case of need replace established on a reception pipe a lambda probe.
5. Survey of an internal surface of an exhaust pipe allows to define the current working condition of the engine. The structure of deposits in a pipe speaks about quality of settings of the engine. If the pipe from within black and smoked, can indicate it that it is necessary to check fuel system carefully.