Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car

Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
- Coupling
   + Coupling
   Driveshaft
   - Power shafts
      Removal and installation of a flange of a power shaft and radial-stop ball bearing
      Removal, check and installation of a power shaft
      Removal and CV JOINT installation of power shafts and their protective covers
   + Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a flange of a power shaft and radial-stop ball bearing

Removal

Flange of a power shaft and radial-stop ball bearing

PERFORMANCE ORDER

1. Remove a power shaft.
2. Remove a brake disk.
3. Remove blocks of the parking brake system.
4. Take a flange of a power shaft (10) (at the established wheel support).
5. Remove a lock ring (9).
6. Remove the radial-stop ball bearing (8) from a wheel support.
7. Take an internal ring of the bearing from a flange of a power shaft.

Check

Check an axial and radial beating of a flange (10) of a power shaft. The extreme admissible size of an axial side play of a flange makes 0.03 mm, a radial beating - also 0.03 mm.

Installation

Installation is carried out as it should be, the return to removal.

Flange of a power shaft

Removal

Removal of a flange of a power shaft

PERFORMANCE ORDER

1. Insert a carving bolt (010j) into a flange (10) outside and tighten it to an arm (010g). 2. Install the support plate (010d) on a wheel support.
3. Establish a clamping plate (010f) with a clamping bolt (010b) through an arm and install on the support plate (010d) again.
4. Establish a hydraulic press (010h) between persistent laying (010f) and an arm (010g). Turn off clamping a bolt (010k) from a hydraulic press, then a bolt (010i) of an arm until it does not concern the clamping cylinder of a hydraulic press.
5. Screw clamping a bolt (010k) of a hydraulic press (the maximum moment of 40 Nanometers) until the flange of a power shaft is not removed).
6. Strike with the hammer an arm (shooter).
7. If it will be not enough, turn out a bolt (010i) from an arm.

Installation

Installation of a flange of a power shaft


7 — a wheel Support 8 — the Two-row radial-stop ball bearing

Install a flange (10) on the two-row radial-stop ball bearing (8), using the adjusting tool (08a) - (08s), (08e) - (08i). Make sure that the small clamping plate (08s) is correctly established on an internal ring of the bearing (shooter).

Two-row, radial-stop ball bearing

Removal of the two-row radial-stop ball bearing


7 — a wheel Support 08 — the Two-row radial-stop ball bearing 08a — the Bolt with a nut 08b — the Stripper 08s — Persistent laying (small)

Installation of the two-row radial-stop ball bearing


7 — a wheel Support 8 — the Two-row radial-stop ball bearing 08a — the Bolt with a nut 08b — the Stripper 08s — Persistent laying (small) 08e — Clamping the bearing